Re: Hello from a new list member - couple questions
Michael <[email protected]> Tue, 17 Jan 2017 01:53:42 -0500
| Newsgroups | gmane.os.netbsd.ports.hp300 |
|---|---|
| Organization | The NetBSD Foundation |
| Message-ID | <20170117015342.4af5ea95@blackbush> |
Hello, On Mon, 16 Jan 2017 11:27:52 -0800 Pete Lancashire <[email protected]> wrote: > I've started to work away at getting a couple 9000/385's up. > > I acquired them from a surplus dealer (not eBay for a change) and > were in great shape, except that the original owner had pulled the > hard drives and as usual no keyboards. Nice! > I've order a couple SCSI1-2 to 68 and 80 PIN adapters, and have > a few unused drives. You may run into problems here. I've had a hp9000/345, its onboard SCSI controller ( or the ROM firmware, who knows ) caused it to only boot from actual SCSI-I drives, apparently timings were more relaxed for SCSI-II so many SCSI-II drives were not recognized. This applies only to the ROM though, NetBSD has no such problems. My workaround was to boot the kernel from a SCSI ZIP drive ( which apparently conformed to SCSI-I specs ) and then have the root fs on an actual harddisk. Also, all HP9000 can boot over network, although not necessarily over ethernet. IIRC you need a rev. D ROM for that. > I've got a HIL keyboard in pretty bad shape but should function, > If it does not work, I bite the bullet and buy one for now off eBay. IIRC there's a switch at the back for a serial console. There should be a serial port on either the CPU board or the human interface board - not sure which the 385 uses. > Memory. Does anyone know if the largest memory SIMM one > can use is 8MB, for a total of 32 MB ? They both came with > 2x8MB or 16MB and would like to max them out. No idea, my 245 had 16MB on 8 modules but I've heard of people having up to 128MB in machines like that. > GPIB: My goal is to use at least one of them for a GPIB to instrumnet > controller, anyone else on the list doing this ? For *that* you might be better off with Rocky Mountain BASIC. > So far, I've powered one up using a old LCD monitor and the thing powers > up, but w/o a keyboard I just have to wait. IIRC all the HP colour graphics boards are sync-on-green. have fun Michael