Re: HP 9000 Model D330 working?

On Tue, 31 May 2005 19:46:01 +0200
Christian Hattemer <[email protected]> wrote:

> The install notes advise to copy SYSNBSD from the installation
> directory of the release to /tftpboot.
[...]
I suspect the install notes are out of sync. netinstall.lif is what you
need.

> There's "differential scsi" printed on them.
OK, you have HVD SCSI disks.

> The frames are much
> longer than a drive usually is. Is there more than the drive inside?
I don't know.

> Can the drive be exchanged?
If you can find an other HVD SCSI disk...

> Is there something special about the SCSI ID to set for the disk?
No. You can set the device path for the primary boot device to any disk.

> BTW: It was said X wouldn't work, but there are X sets in the release?
> Does this machine have X support at all?
No X. The sets are just for the X clients.
-- 


tschüß,
       Jochen

Homepage: http://www.unixag-kl.fh-kl.de/~jkunz/