Re: z50 POST error 203?

>> So I removed the battery and put it back, which is my usual recovery
>> procedure for total wedging.
> Check your battery lock switch, Is it "LOCKED"?

Yes.  Without that, the power button won't do anything - it won't even
power up far enough to _try_ POST.

I found a manual which says error 203 indicates a DRAM problem.  So
I've reseated the RAM (and the ROM for good measure) and I'm still
getting 203 - but when I pull the module and let it use just the
onboard RAM, it boots to WinCE.  So it's the RAM module (or something
unique to it, such as an interface chip).

I have another, much smaller, module, which I swapped out in favour of
the module that's in there now; I'll try swapping that in.  This module
is Kingston memory, bought from (if memory serves - I'll have to check
this) MemoryX, so there's a good chance it's still under warranty....

/~\ The ASCII				der Mouse
\ / Ribbon Campaign
 X  Against HTML	       [email protected]
/ \ Email!	     7D C8 61 52 5D E7 2D 39  4E F1 31 3E E8 B3 27 4B