Re: LSI MegaRAID installation

Fujitsu 
Tech Support tell me the chip is vendor 8086 product a106.

I have gone back to square one, initialised a pair of disks in RAID 1
mode, set the BIOS to RAID rather than AHCI mode, and see from dmesg
that this configures at ahcisata0.

According to Ubuntu it is an LSI SAS-3 3108 (Invader).

So: is there currently no driver? is there something I am not doing
correctly so that the RAID controller is not recognised?  or am I just
misunderstanding what I should expect to see in the install process (I
was expecting to see one virtual disk to partition, not two physical
disks).

--
Steve Blinkhorn <[email protected]>

You wrote:
> 
> On Mon, 30 Apr 2018, Mouse wrote:
> >>> I can't see anything in dmesg.boot: it's conceivable that if RAID
> >>> mode is not configured in the BIOS then the chip won't show up I
> >>> suppose.
> >
> >> You will still see the PCI device, e.g.:
> >
> >> vendor 1000 product 0016 (RAID mass storage, revision 0x01) at pci11 dev 0 function 0 not configured
> >
> > Sometimes.
> >
> > I have seen cases where, as Steve says, a device that's disabled at the
> > BIOS config level is not visible on the system buses at all.  Is there
> > some reason it's impossible this could be such a case?
> 
> Depends what his definition of "RAID mode is not configured in the BIOS" 
> means. In my experience with MegaRAID stuff, this would mean "haven't 
> created any virtual drives yet" - on modern uEFI you do this through the 
> BIOS/uEFI settings.
> 
> -- 
> Stephen
> 
> 


-- 
Steve Blinkhorn <[email protected]>

****************************************************************************
This email is for the addressee only.   If you are not the addressee
you should immediately delete this email from your system(s) and
inform us.   It may contain information that is confidential or
otherwise privileged, and should not be copied or redistributed to
recipients not originally specified as addressees without permission.

S F Blinkhorn MA PhD CPsychol FBPsS, Managing Director,
Psychometric Research & Development Ltd.
PO Box 1143, St Albans, Herts, AL1 9UT, UK
Registered in England No. 1909571
Registered Office: 45 Grosvenor Rd., St Albans, Herts, AL1 3AW
Phone: +44 (0)1727 841455
http://www.prd.co.uk
****************************************************************************