Re: 6.1.4 running on a Performa 450 / LCIII

I would think it should just be a matter of pulling
xsrc/xfree/xc/programs/Xserver/hw/netbsd/mac68k into
xsrc/external/mit/xorg-server/dist/hw/netbsd/x68k, flipping X11FLAVOUR for
mac68k in share/mk/bsd.own.mk and then tweaking the build...

Not a trivial task, but could be an interesting project for someone with
some time and an inquiring mind :)


On 25 May 2014 12:25, Bjarne Bäckström <[email protected]> wrote:

>
> 25 maj 2014 kl. 00:27 skrev David Brownlee <[email protected]>:
>
> […]
>
> makemandb: Error in indexing /usr/X11R6/man/man3/XvStopVideo.3
>> Parsing: /usr/X11R6/man/man3/XvUngrabPort.3
>> makemandb: Error in indexing /usr/X11R6/man/man3/XvUngrabPort.3
>> Parsing: /usr/X11R6/man/man3/XvVideoNotify.3
>> makemandb: Error in indexing /usr/X11R6/man/man3/XvVideoNotify.3
>> Total Number of new or updated pages encountered = 21
>> Total number of (hard or symbolic) links found = 3
>> Total number of pages that were successfully indexed/updated = 0
>> Total number of pages that could not be indexed due to errors = 21
>> Deleting stale index entries
>>
>
> While stopping makemandb from running on every boot is probably the best
> fix for you (echo makemandb=NO >> /etc/rc.conf), these errors seem to be
> caused by some X11R6  manpages being in a format makemandb cannot handle.
> This was probably not noticed sooner because most NetBSD ports ship with
> X11R7 now.
>
>
>    Thanks! I figured that from earlier replies (my own replies seem to
> sometimes get stuck somewhere).
>
>    Does anybody (who’s reading this list) know if the ports of R7 to
> mac68k is in the works?
> —
> Regards,
> /Bjarne.
>
>