The first reboot to hard drive after the CD-rom install failed
Mark Grieveson <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.macppc |
|---|---|
| Message-ID | <[email protected]> |
Hello. I used a CD-rom, created from NetBSD-9.0-macppc.iso, to install NetBSD onto an iBook G4. The iBook G4 accessed the CD via the Open Firmware command, "boot cd:,\ofwboot.xcf netbsd.macppc'' (as instructed in the manual). I only have WiFi, so I did not enable any network connections. I figured I could set up the WiFi later when I could install proper drivers for the Broadcom firmware of the iBook G4. Anyway, the install seemed to go well. Everything was installed from the CD-rom, which had the full sets on it. It finished and I was told by it to reboot to the OS now on the hard drive. But, instead, it went to the Open Firmware prompt of the iBook G4 (the little icon that changes back and forth into a question mark). I'm not sure how to fix this. Mark