Re: emips status?
Havard Eidnes <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.mips.devel |
|---|---|
| Message-ID | <[email protected]> |
>> [...] it gets a bit further, doesn't panic anymore, but also is not >> <break>able into DDB, so as far as I can see it's wedged. Hints >> for next steps appreciated. Dmesg so far attached below. ... >> ps2 at ebus0 addr 0xfff30000 not configured >> ac97 at ebus0 addr 0xffef0000 not configured >> rnd: WARNING! initial entropy low (7). >> rnd: entropy estimate 0 bits >> rnd: asking source callout for 512 bytes >> rnd: WARNING! initial entropy low (0). >> rnd: entropy estimate 0 bits >> rnd: asking source callout for 512 bytes >> rnd: cpu0 attached as an entropy source (collecting) >> (hang) > > Can't you get the emulator to tell you want it's stuck on / doing? Caveat: this is as far as I could get with a couple of hours late one evening... The emulator is run from the Windows CLI and doesn't appear to have a graphical UI making it possible to stop/single-step or inspect state. Admittedly, I don't have Visio installed, but browsing the presentation material I get the impression that's only for editing "machine configurations". So, "no", apparently. Regards, - Håvard