RE: SGI O2 unable to boot 9.0+ (status update)

Hi All,

I checked a few more things.

1)R12000
I checked whether it would boot on my O2 with R12000, and it all booted with
7.2, 8.3 and 9.[0-3].
This check, and all the previous checks, were done using the serial console.

2)R5000
I regularly use the serial console, but I tried to check whether it would
boot using the graphics console.
I have only tried one so far, but I was unable to boot netbsd-GENERIC32_IP3x
of 9.0 (which could be booted with the serial console).
The kernel started, displayed a few messages, then suddenly shut down before
displaying the copyright message. It won't turn on, so I'm planning on using
jumpstart to recover it.
There seem to be other problems besides PR#57654 mentioned in the previous
email.

Regards,
-- 
Yoshihiko Iwama