Re: Trouble netbooting MVME167B

On Tue, 12 Aug 2003, Steve Woodford wrote:

> On Tue, 12 Aug 2003, Henning Kiel wrote:
>
> > Now I can boot the kernel:
> > I tried netbsd.RAMDISK and netbsd-GENERIC (should be the same? only
> > without ramdisk) and netbsd-MVME167. But with these I get a kernel panic:
> >
> > ...
> > ie0 at pcctwo0 offset 0x4000 ipl 3 address 08:00:3e:26:e5:db, type onboard
> > osiop at pcctwo0 offset 0x5000 ipls 2trap byte 0, code = 0x125, v = 0xb77021
> > pid = 0......
> > And then the registers and kernel stack
> > panic: Bus error
> > halted
>
> Can you post the complete kernel boot messages, plus the registers and
> stack trace please.

Difficult. I'm using a VT100 device here. I tried to connect with my
Linux-PC, but didn't succeed. I have 9-pin Nullmodem cable (wires 2-3 and
3-2, and gnd (5 or so...) connected).
With "cat /dev/ttyS0" I don't get the MVME's output (I set the baudrate to
9600 and 8N1 no handshake). Also with a Kermit program i cannot connect.
Am I doing something wrong?

Chau,
Henning