Re: Efika 5200B

On Mon, 11 May 2015 21:05:14 +0200
BERTRAND Jo=EBl <[email protected]> wrote:

> >> firmware seems to load kernel but this kernel panics with "no
> >> /dev/console" message.
> >
> > Hm. Not sure about that, but IIRC a simple console should work via OFW.
> > Maybe I find some time to test a recent kernel on one of my Efikas these
> > days. Then I will report back.
>=20
> 	I'm waiting for your tests.

Tested a recent kernel today (loaded via TFTP). I have connected a serial
console, so I can paste the output here:

---8<---
Welcome to SmartFirmware(tm) for bplan EFIKA5K2
Version 1.3 (20070122084838)
SmartFirmware(tm) Copyright 1996-2001 by CodeGen, Inc.
All Rights Reserved.
Pegasos BIOS Extensions Copyright 2001-2007 by bplan GmbH.
All Rights Reserved.
Auto-boot in 3 seconds - press ESC to abort, ENTER to boot: aborted
ok boot eth netbsd799-efika
mem region 0 start=3D0 size=3D8000000
avail region 0 start=3D0x19111e4 size=3D0x66eee1c
[ Kernel symbol table missing! ]
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 7.99.5 (GENERIC) #0: Tue May 12 10:54:47 CEST 2015
        frank@tethys:/home/frank/netbsd/current/src/objofppc/sys/arch/ofppc=
/compile/GENERIC
Model: EFIKA5K2
total memory =3D 128 MB
avail memory =3D 99 MB
bootpath:=20
mainbus0 (root)
rtas0 at mainbus0: version 1, entry @pa 0x1cc5000
cpu0 at mainbus0: G2 (Revision 1.4), ID 0 (primary)
cpu0: HID0 0x90c000<DOZE,DPM,ICE,DCE>, powersave: 1
cpu0: L1 I-cache 16 KB 32B/line, D-cache 16 KB 32B/line
ofwpci0 at mainbus0
pci_configure_bus() failed
pci0 at ofwpci0 bus 0: OFW method configuration space access
genfb0 at pci0 dev 16 function 0: vendor 1002 product 5960 (rev. 0x01)
genfb1 at pci0 dev 16 function 1: vendor 1002 product 5940 (rev. 0x01)
vmmask 0 schedmask 0 highmask 0
boot device: cpu0
can't determine root device
root device (default cpu0):=20
---8<---

Ok, that's not much. But I don't see a kernel panic or messages about
missing /dev/console.

Robert Swindells worked on Efika support six years ago, and there was
a kernel, which detected a lot more devices and already had an mpc5200-
specific interrupt handler:

http://mail-index.netbsd.org/port-ofppc/2009/07/oindex.html

Maybe you want to try his latest patches:
ftp://ftp.netbsd.org/pub/NetBSD/misc/rjs/


> I have found this ppc board and I'm
> trying to find a runnable operating system (that is not Linux as this
> board only has 128 MB).

Yes, having NetBSD on this nice little board would be great.

--=20
Frank Wille