Re: Dead (?) DS5000/200

Sorry, you would think by now I would know to give all the info I have.

1) System has a PMAD-A ethernet turbochannel in slot 1 and a PMAG-B board
in slot 0  in it.  No keyboard or monitor attached.  Haven't tried pulling
the TC boards yet.

2) Diagnostic LEDs on the back are coming up with a 7B code.  If I pull the
memory out I get a 73.  If I put one board in slot 1 (2nd slot) I get a 73
also.

G



On Sat, Oct 29, 2016 at 4:14 PM, Gordon Zaft <[email protected]> wrote:

>
> I had a DECstation 5000/200 that had been working fine, but was in storage
> for 4+ years.  Pulled it out and fired up the serial console and...
> nothing.  Powers on, but no output on serial console.  (same setup works
> fine with a DS5000/240 I have).
>
> I pulled all the memory and put just one board in.  No dice.  Tried
> several others, one at a time in slot 0.  No luck.
>
> Any suggestions, or is it just dead?
>
> --
> Gordon Zaft
> Province 35 Governor
> Phi Mu Alpha Sinfonia Fraternity
> [email protected]
>



-- 
Gordon Zaft
Province 35 Governor
Phi Mu Alpha Sinfonia Fraternity
[email protected]