Re: 2100: selftest failure?

hmm, maybe try swapping some memory out? see if any of it is really bad? 

On Wed, 22 Dec 2004, der Mouse wrote:

> I have a 2100 that I had doing some compiles.  Then power went out.
> 
> Knowing that it's usually not losing power that fries electronics but
> regaining it at the same time as everything else on that branch circuit
> is starting up, producing really dirty power for a second or two, I
> turned off the machine room at the breaker box.  Something like half an
> hour after power came back, I turned it back on.
> 
> Now, the 2100 produces nothing on its serial console, and the LEDs stop
> at 11101111, which according to one past message google found for me
> has something to do with memory.  I've waited way longer than its
> selftest ever took before.
> 
> Neither break nor ^C at the serial console do anything.  Pressing the
> reset switch (next to the BNC Ethernet) makes the LEDs go all-on; upon
> releasing it, they promptly return to 11101111.
> 
> Is this normal for any sort of RAM failure (and thus it may be as
> simple as reseating the RAM), or does it mean something more
> fundamental is wrong, like a toasted RAM controller, or is it
> impossible to tell, or what?
> 
> Is there any way to get an more informative diagnostics out of it?
> 
> /~\ The ASCII				der Mouse
> \ / Ribbon Campaign
>  X  Against HTML	       [email protected]
> / \ Email!	     7D C8 61 52 5D E7 2D 39  4E F1 31 3E E8 B3 27 4B
>