boot after install

"Paul JURCO" <[email protected]>
Newsgroups gmane.os.netbsd.ports.prep
Message-ID <004801c3dcf2$383acd80$9e07e2c1@paul> 
Hi,
I've installed NetBSD on IBM 43P-120 and I have 
dd generic.fs to /dev/sd0c (generic_com0.fs) doesn't boot at all.
At the boot time I am asked about root device, I've typed sd0a, 
where my root partition resides, and sd0b as dump device (swap 
partition), but it panics because it doesn't find init.

What should I do?

It's a 43P-120 64Mb RAM,
SCSI hdd [2150 MB]

Thanks in advance,
Paul JURCO
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.