More installation woes, can't get ip working

Okay, the adapter DID work under the sysinst.fs, of that, I am sure.  
Now that I'm booted under generic.fs floppy with root on hard drive, it 
doesn't.  I am using generic_com0.fs provided by Jochen Kunz.  This is 
an output of what I've got so far:

# /etc/rc.d/network restart
Stopping network.
Deleting aliases.
Downing network interfaces: pcn0.
Starting network.
Hostname: ganymede
IPv6 mode: host
Configuring network interfaces: pcn0.
add net default: gateway 192.168.0.1
Adding interface aliases:
# ifconfig pcn0
pcn0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        address: 00:06:29:21:07:a0
        media: Ethernet 10baseT
        inet 192.168.0.9 netmask 0xffffff00 broadcast 192.168.0.255
        inet6 fe80::206:29ff:fe21:7a0%pcn0 prefixlen 64 scopeid 0x1
# netstat -rn -f inet
Routing tables

Internet:
Destination        Gateway            Flags     Refs     Use    Mtu  
Interface
default            192.168.0.1        UGS         0        0      -  pcn0
127/8              127.0.0.1          UGRS        0        0  33196  lo0
127.0.0.1          127.0.0.1          UH          1        0  33196  lo0
192.168/24         link#1             UC          1        0      -  pcn0
192.168.0.1        link#1             UHLc        1        0      -  pcn0
# cat 
/etc/ifconfig.pcn0                                                      
inet 192.168.0.9 broadcast 192.168.0.255 netmask 255.255.255.0
# grep defaultroute 
/etc/defaults/rc.conf                                     
defaultroute="192.168.0.1"
# ping 192.168.0.1
PING 192.168.0.1 (192.168.0.1): 56 data bytes
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down


Link light is NOT lit on hub.

Any ideas?  Please help,

timbo
mailto:[email protected]