Re: Fixes for 43p-140?
Jochen Kunz <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.prep |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 26 Aug 2005 20:43:01 -0700 Andy Ruhl <[email protected]> wrote: > 1. How to set the firmware to a serial console > 2. How to get it to boot from floppy or the network before going to > disk > > I get to a firmware prompt, I think with F4? But then I'm not able to > get it to boot from floppy. It reads it but with no console output (on > the VGA) and it just hangs. IIRC you get to a setup menu with F2 (?) where you can alter this settings. You should be able to set this from the OpenFirmWare also by altering the environement variables. Run "printenv" in the OFW... -- tschüß, Jochen Homepage: http://www.unixag-kl.fh-kl.de/~jkunz/