Re: 43p: Install kernel boots, generic not

Hi,

> > I keep answering my own questions... Sorry, I hope this monologue does
> > help other people.
> 
> Its a fascinating thread for those of us with other (non port-prep)
> vintage hardware :)

Well, that's good to hear, at least I can provide a bit of entertainment ;-)

> > I found out what the problem was/is: apparently, the firmware seems to
> > have a limit for the file size it can boot. It's somewhere below 2M.
> > I was able to boot my 43p with a kernel build by this configuration:
> > [... kernel config ...]
> 
> Does it load to the ">> NetBSD/prep BOOT" stage and then fail? If so I
> wonder if its an issue with the NetBSD bootloader not being able to
> find a large enough contiguous chunk of memory (which I would imagine
> should be fixable).

No, in that cases it looked like this:
-----------------------snip------------------------
0 > boot net 
LOAD: Waiting 60 seconds for Spanning Tree
BOOTP R = 1 BOOTP S = 1  
FILE: generic_com0.fs
Load Addr=0x600000 Max Size=0x10000000 
Packet Count = 100...FINAL Packet Count = 5181   Final File Size = 2652339 bytes.


-----------------------snip------------------------

The firmware printed a last newline and the box died on the spot,
like the firmware has a wrap-around on load or something like that.

> Do kernel modules work on port-prep - an easy way to test might be to
> try 'modload efs' and then 'modstat'. That could be a way to keep the
> base kernel down while still being able to support everything

Well, the first kernel with the option enabled died on boot-up,
is there something to watch out for? It was not selected in the GENERIC
kernel for prep anyway, so I think that's more work for later...

CU,
Uli
-- 
Dipl. Inf. Ulrich Teichert|e-mail: [email protected] | Listening to:
Stormweg 24               | Syndrome 81: Le Condor De La Rade, The Briefs:
24539 Neumuenster, Germany| She's The Rat, The Bellrays: Bad Reaction