Re: 43p: Install kernel boots, generic not

Hi,

> have you tried installing a PCI graphics card into the 43-140 and using 
> the non-com version of sysinst.fs? In my testing, I only had the siop 
> problem at boot when using the serial port.

No, never tried that. There is a PCI graphics card in my 43p, but
I think this isn't supported. From a bootlog:
....
vendor 1014 product 0046 (undefined, subclass 0x00) at pci0 dev 13 function 0 not configured
siop0 at pci0 dev 16 function 0: Symbios Logic 53c825a (fast wide scsi)
siop0: using on-board RAM
siop0: interrupting at irq 23
scsibus0 at siop0: 16 targets, 8 luns per target
vendor 1014 product 0054 (miscellaneous display, revision 0x01) at pci0 dev 18 function 0 not configured
ppb0 at pci0 dev 23 function 0: vendor 1014 product 0022 (rev. 0x01)
pci1 at ppb0 bus 1
isa0 at pcib0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
...
According to devicehunt.com, it's a "GXT500P/GXT550P Graphics Adapter"
from IBM. What card are you using?

TIA,
Uli
-- 
Dipl. Inf. Ulrich Teichert|e-mail: [email protected] | Listening to:
Stormweg 24               |Eat Lipstick: Dirty Little Secret, The Baboon Show:
24539 Neumuenster, Germany|Work Work Work, The Bellrays: Bad Reaction