Re: Synology PPCBoot SK98 network bug fix

Frank Wille <[email protected]> Wed, 1 Jun 2011 13:10:26 +0200

Newsgroups	gmane.os.netbsd.ports.sandpoint
Organization	Privates Internet Ostwestfalen/Lippe
Message-ID	<[email protected]>

On Tue, 31 May 2011 15:10:52 +0100
Julian Coleman <[email protected]> wrote:

> The if_sk.c driver copies SK_MAC1_0 into YUKON_SA2, so I initially
> tried this ...
> 
> > 3. Enable unicast and multicast filters by writing setting MUFLEN
> > and UFLEN (0xc000) in YUKON_RCR.
> 
> ... and enabled both filters.  This resulted in timeouts, so I tried
> copying the same address into SA1 and SA2.  Still timeouts

Indeed. I tried that too last night. No idea what is missing.

> (but it works fine with just the multicast filter enabled).

Ok. When you don't see another solution I would commit the code enabling
the multicast filter.

Then I can mark the DS-207 as officially supported on the sandpoint page? :)

-- 
Frank Wille