Re: Set 100Mb card not working on 5.0

> tsutsui@ appears to have most recently modified tl(4). Perhaps he can  
> confirm that it's not broken on other ports.

5.99.11 macppc GENERIC kernel says:

tl0 at pci0 dev 13 function 0
tl0: Compaq Netelligent 10/100 TX
tl0: Ethernet address 00:80:5f:8b:55:cc
tl0: interrupting at irq 23
nsphy0 at tl0 phy 1: DP83840 10/100 media interface, rev. 1
nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
tlphy0 at tl0 phy 31: ThunderLAN 10BASE-T media interface, rev. 5
tlphy0: no media present

(note no media tlphy0 is correct in this card
 because actually there is no connector on it)

> > I have a Set Engineering 100Mb Ethernet card which looks like it's not
> > being fully recognised by NetBSD 5.0. The machine is a R4400  
> > Challenge S
> > and the card shows up as:
> >
> > giopci0 at gio0 slot 1 addr 0x1f400000: Set Engineering GFE 10/100
> > Ethernet pci0 at giopci0 bus 0
> > pci0: memory space enabled
> > tl0 at pci0 dev 0 function 0
> > tl0: Texas Instruments ThunderLAN
> > tl0: Ethernet address 08:00:69:02:9e:21
> > tl0: interrupting at slot EXP0

Which version? 5.0 GENERIC?
What lines appear in the next?
---
Izumi Tsutsui