Flow control issues with scif?

"Valeriy E. Ushakov" <[email protected]>
Newsgroups gmane.os.netbsd.ports.sh3
Message-ID <[email protected]> 
I have flow control issues with scif in jornada680.  On transmit
everything is fine, but on receive scif driver loses incoming bytes.
This makes it impossible to run ppp over scif.  Using cu is
problematic as well, b/c a lot of output from the host gets dropped.

Is this a known problem?

SY, Uwe
-- 
[email protected]                         |       Zu Grunde kommen
http://www.ptc.spbu.ru/~uwe/            |       Ist zu Grunde gehen
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.