Re: Stopping the timekeeper clock (Was: New Timekeeper/RAM clock stops on power loss?)

> I haven't tried this out yet on sparc (nor sun3).  They have m48t08
> or m48t02 without a battery low flag, so there will only be the
> sysctl to stop/start the oscillator.  I don't know if their firmware
> starts the oscillator or not, [...]

In my experience, sparc ROM code always starts the oscillator during
POST.  I don't recall ever seeing a SPARC with the oscillator stopped
but the ROM code not starting it; of course, this could just be due to
limited experience with certain systems.

/~\ The ASCII				  Mouse
\ / Ribbon Campaign
 X  Against HTML		[email protected]
/ \ Email!	     7D C8 61 52 5D E7 2D 39  4E F1 31 3E E8 B3 27 4B