Re: Anyone have working pre-v8 machines?
Mouse <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.sparc |
|---|---|
| Message-ID | <[email protected]> |
>> ...? 8.x and 9.x don't boot at all? Not netboot? Not even if you >> put the data on the disk with another machine? [...] > To be honest, I did not try netbooting. It is always a hassle, but > could be a nice to test to be sure that the "only" problem is the > boot blocks Netbooting is one of my first go-to alternatives for booting troubles, but in my case I have a machine already set up specifically to be a netboot (RARP, DHCP, NFS, etc) server. > I did not try yet "installing" from another machine, perhaps I could > use my other sparcstation, put the hard disk in an enclosure and try > installing on it? Possibly. I would prefer that myself anyway, because I don't like to run disks inside my SS20s for heat dissipation reasons. (I have two SS20s in routine live use right now and in each case the disk is external.) > I avoid that if possiblethouhg, I do not like moving in-out of hard > disks on these old machines, connectors and 50pins are brittle. I thought the SS20's internal disk connectors were SCA, not 50-pin. Am I misremembering? > Also, I fear if the installer does not load, why should the installed > system load better? Maybe it won't. But I've seen cases where one loads and the other doesn't often enough in the past that I tend to be suspicious. Also, some people, when writing to the list, do not draw any distinction between "install media bootblocks error out" and "install kernel errors out" and "installer runs but installed booter fails" and the like; it all ends up described as as "I tried to install and it didn't work". Suggesting alternatives and asking for details often clarifies exactly what's breaking. >> What goes wrong when you try? > Data access exception. It appears to be the same issue I had in > 2014. > Many years ago I was able to "install" but not boot again and somehow > I tested many boot blocks until I found one that worked and "kept" > it. Until I decided to upgrade again... I don't know whether it's relevant to your particular case, but I do know that there have been times, on some architectures, when bootblocks older than a certain change can't load kernels newer than that change, or when bootblocks older than time T1 can't load kernels bigger than some size, and at a time later than T1 the kernel grew to exceed that size, or the like. I don't recall trying anything even vaguely recent on my SPARCs (the most recent I've tried is, I think, 5.2), so I have no relevant personal experience. I could probably grab a scratch disk and do a test install of 9.x on it, but probably not very soon. /~\ The ASCII Mouse \ / Ribbon Campaign X Against HTML [email protected] / \ Email! 7D C8 61 52 5D E7 2D 39 4E F1 31 3E E8 B3 27 4B