Re: Booting 10.0 from CD on Sparc IPC fails - Data Access Exception

Hi Julian

Julian Coleman wrote:
> I finally had a chance to build the ISO and the miniroot with the patch:
>
>    https://ftp.netbsd.org/pub/NetBSD/misc/jdc/sparc/boot/NetBSD-10.0_STABLE-sparc.iso
>    https://ftp.netbsd.org/pub/NetBSD/misc/jdc/sparc/boot/miniroot.fs.gz

cool! I switched to 2.4 back, new command mode...
Slapped your miniroot on swap and tried.

I think it works!!

Can I safely use that to install/upgrade and it will install also good 
boot blocks?


Riccardo


ok boot disk:b netbsd -s
Boot device: /sbus/esp@0,800000/sd@3,0:b   File and args: netbsd -s
 >> NetBSD/sparc Secondary Boot, Revision 1.15 (Thu May 30 19:27:37 UTC 
2024)
Booting netbsd
4893836+130644 [307760+289523]=0x55cd08
OBP version 2, revision 2.4 (plugin rev 2)
[   1.0000000] Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003,
[   1.0000000]     2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 
2013,
[   1.0000000]     2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 
2023,
[   1.0000000]     2024
[   1.0000000]     The NetBSD Foundation, Inc.  All rights reserved.
[   1.0000000] Copyright (c) 1982, 1986, 1989, 1991, 1993
[   1.0000000]     The Regents of the University of California.  All 
rights reserved.

[   1.0000000] NetBSD 10.0_STABLE (GENERIC) #0: Thu May 30 21:37:52 CEST 
2024
[   1.0000000] 
jdc@morava:/mnt/obj/netbsd-10/sparc/mnt/cvs/netbsd-10/src/sys/arch/sparc/compile/GENERIC
[   1.0000000] total memory = 48752 KB
[   1.0000000] avail memory = 42164 KB
[   1.0000000] bootpath: /sbus0/esp@0,800000/sd@3,0:b
[   1.0000000] mainbus0 (root): SUNW,Sun 4/40: hostid 52c1fea2
[   1.0000000] cpu0 at mainbus0: SUNW,Sun 4/40 @ 25 MHz, WTL3170/2 FPU
[   1.0000000] cpu0: 64K byte write-through, 16 bytes/line, sw flush: 
cache enabled
[   1.0000000] memreg0 at mainbus0 ioaddr 0xf4000000
[   1.0000000] clock0 at mainbus0 ioaddr 0xf2000000: mk48t02
[   1.0000000] timer0 at mainbus0 ioaddr 0xf3000000 ipl 10: delay 
constant 10, frequency = 1000000 Hz
[   1.0000030] auxreg0 at mainbus0 ioaddr 0xf7400003
[   1.0000030] zs0 at mainbus0 ioaddr 0xf1000000 ipl 12 softpri 6
[   1.0000030] zstty0 at zs0 channel 0 (console i/o)
[   1.0000030] zstty1 at zs0 channel 1
[   1.0000030] zs1 at mainbus0 ioaddr 0xf0000000 ipl 12 softpri 6
[   1.0000030] zstty4 at zs1 channel 0
[   1.0000030] kbd0 at zstty4
[   1.0000030] zstty5 at zs1 channel 1
[   1.0000030] ms0 at zstty5
[   1.0000030] wsmouse0 at ms0 mux 0
[   1.0000030] audioamd0 at mainbus0 ioaddr 0xf7201000 ipl 13
[   1.0000030] audio0 at audioamd0: playback, capture, full duplex
[   1.0000030] audio0: slinear_be:16 -> mulaw:8 1ch 8000Hz, blk 320 
bytes (40ms) for playback
[   1.0000030] audio0: slinear_be:16 <- mulaw:8 1ch 8000Hz, blk 320 
bytes (40ms) for recording
[   1.0000030] sbus0 at mainbus0 ioaddr 0xf8000000: clock = 25 MHz
[   1.0000030] dma0 at sbus0 slot 0 offset 0x400000: DMA rev 1
[   1.0000030] esp0 at sbus0 slot 0 offset 0x800000 level 3: ESP100A, 
25MHz, SCSI ID 7
[   1.0000030] scsibus0 at esp0: 8 targets, 8 luns per target
[   1.0000030] le0 at sbus0 slot 0 offset 0xc00000 level 5: address 
08:00:20:c1:fe:a2
[   1.0000030] le0: 8 receive buffers, 2 transmit buffers
[   1.0000030] bwtwo0 at sbus0 slot 3 offset 0x0 level 7: SUNW,501-1561, 
1152 x 900
[   1.0000030] bwtwo0: attached to /dev/fb0
[   1.0000030] wsdisplay1 at bwtwo0 kbdmux 1
[   1.0000030] fdc0 at mainbus0 ioaddr 0xf7200000 ipl 11 softpri 4: chip 
82072
[   1.9406120] scsibus0: waiting 2 seconds for devices to settle...
[   1.9558030] wskbd0 at kbd0 mux 1
[   2.0306430] WARNING: system needs entropy for security; see entropy(7)
[   4.8908740] entropy: best effort
[   5.3309450] kbd0: reset failed
[   5.4710270] sd0 at scsibus0 target 3 lun 0: <SEAGATE, ST32272N, 0876> 
disk fixed
[   5.5010470] sd0: 2157 MB, 6300 cyl, 4 head, 175 sec, 512 bytes/sect x 
4419464 sectors
[   5.5310430] sd0: sync (200.00ns offset 15), 8-bit (5.000MB/s) 
transfers, tagged queueing
[   6.9611700] swwdog0: software watchdog initialized
[   7.0311440] root on sd0b dumps on sd0b
[   7.1211060] root file system type: ffs
[   7.1324280] kern.module.path=/stand/sparc/10.0/modules
erase ^H, werase ^W, kill ^U, intr ^C