Re: specifying root / adding a hard disk

On Fri, Jul 5, 2024 at 6:28 AM Riccardo Mottola
<[email protected]> wrote:
>
> Hi!
>
> my SS4 is tight on disk space. The internal Hard disk is SCSI Target 3,
> pretty standard!
>
> Now I want to attach an external hard disk I use on the IPC, I could use
> and add the swap partition.
>
> Actually i could even then try to install 9.4 on it externally and do
> some tests...
>
> External disk is set to Target 5, but probe-scsi sees it as target 0.
> Even if I change it to 4, it still things it is Target 0, maybe it is
> broken or not connected.

Sounds like you are missing the connection between the enclosure ID
setting and the drive ID jumper block.  There will be a separate
header on the drive of at least 6 pins that has the 3 ID jumpers for a
50 pin drive.  For something like the Sun 411 enclosure I expect there
to be a 6 wire cable coming from the external ID selection that plugs
into that jumper block.

Bob