Re: SUNW,m46B resolutions?
der Mouse <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.sparc64 |
|---|---|
| Message-ID | <[email protected]> |
>> How? I'm not familiar with any interface that allows changing a >> framebuffer's resolution after booting. I even had a quick look at >> the driver and didn't see anything. What should I go read up on? > i don't know much about this, but are you looking at netbsd 3.1 > sources you're missing out on the last 44 revisions to machfb.c. "machfb.c since rev 1.xx" is a perfectly reasonable answer. Actually, I wasn't looking at the 3.1 source; I was looking at 4.0.1, that being the most recent I had at ready hand: machfb.c 1.48.2.1.4.1. Come to think of it, I know where to find unpacked 5.1 source, too. I just now diffed that machfb.c against 4.0.1's and see nothing that looks relevant, so, either it's newer than 5.1 or I'm still missing something. While I'm not _ignoring_ the possibility of the former, I currently consider the latter more likely. /~\ The ASCII Mouse \ / Ribbon Campaign X Against HTML [email protected] / \ Email! 7D C8 61 52 5D E7 2D 39 4E F1 31 3E E8 B3 27 4B