Re: Ultra10 problems with -current

On Nov 1,  7:02pm, [email protected] (Martin Husemann) wrote:
-- Subject: Re: Ultra10 problems with -current

| FWIW: with serial console and -current my U5 says:
| 
| machfb0 at pci1 dev 2 function 0: vendor 0x1002 product 0x4754 (rev. 0x9a)
| machfb0: 16 MB aperture at 0xe1000000, 4 KB registers at 0x00000000
| machfb0: 2048 KB SGRAM 62.999 MHz, maximum RAMDAC clock 170 MHz
| mach64_get_mode: 1152 5304 5432 1528 900 902 938 937
| machfb0: initial resolution 1152x864 at 8 bpp
| machfb0: attached to /dev/fb0
| machfb0: initializing the DSP
| wsdisplay1 at machfb0
| cmdide0 at pci1 dev 3 function 0
| ...
| 
| and boots just fine.
| 
| Maybe it needs a display with edid attached to cause problems? But your
| descriptions sounds like you are using the machfb as console?

I have nothing connected to the display and I am using serial console.

christos