Re: Boot partition

Erik Fair <[email protected]>
Newsgroups gmane.os.netbsd.ports.sparc64
Message-ID <[email protected]> 
On Jul 3, 2014, at 20:02 , Sad Clouds <[email protected]> wrote:

> OK thanks, I'll try to configure it the way you described. By the way
> wd0 is attached to a PCI IDE card, not the onboard IDE controller. I
> think this should work.

Out of curiosity, which sparc64 system is this for? An Ultra 10, perhaps? You might get lucky with a PCI IDE card, if the IDE controller chip is the same one as on the motherboard.

	Erik <[email protected]>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.