Re: can't get tcp/ip to work under qemu/SPARC64/NetBSD 6.1.5

Its been a while since i wrote that guide, and back then the networking and disk emulation had issues..

http://virtuallyfun.superglobalmegacorp.com/category/netbsd/

In the gunkies article i omitted the networking as it was more stable without.

Try adding this:

—net nic,model=e1000 —net user


From Meizu MX4 Pro

-------- Original message --------
Sender: Dennis Luehring <[email protected]>
Time: Tue 8/11 AM 01:01
To: [email protected]
 Subject: can't get tcp/ip to work under qemu/SPARC64/NetBSD 6.1.5

>i try to build a system for while-develop big-endian/unaligned acces 
>checks, got a working debian-sparc64
>running - buts its awfully slow due to 32/64-kernel/userland mixup - 
>NetBSD is pure SPARC64 and is blasting
>fast under qemu - the installation runs very quick (just a few minutes) 
>from CD/with "full without X"
>but i can't get the network to work - trying to use dhcp during 
>installation fails, manual IP settings fail also
>i don't know if it is a hardware(emulation) problem or my little to none 
>knowledge of NetBSD
>
>Qemu:
>
>using git qemu 2.3.93 (latest release 2.2 isn't able to boot NetBSD at all)
>
>needed packages under ubuntu (15.04) for building
>
>g++
>git
>glib2.0-dev
>libfdt-dev
>libgtk2.0-dev
>libncurses5-dev
>libpixman-1-dev
>libsdl1.2-dev
>libvte-dev
>zlib1g-dev
>
>git clone git://git.qemu-project.org/qemu.git
>cd qemu
>./configure --target-list=sparc64-softmmu
>make // no "make install" neeeded
>
>Image:
>
>using the SPARC64 NetBSD 6.1.5 iso image
>ftp://iso2.de.netbsd.org/pub/NetBSD/iso/6.1.5/NetBSD-6.1.5-sparc64.iso
>
>base on this small howto:
>http://gunkies.org/wiki/Installing_NetBSD_6.1.5_Sparc64_on_Qemu
>
>Create image:
>~/qemu/qemu-img create -f raw ~/netbsd/netbsd-615-sparc64.raw 2G
>
>Start installation (use cd0c if asked)
>~/qemu/sparc64-softmmu/qemu-system-sparc64 -m 1024 -nographic -monitor 
>telnet::4440,server,nowait -serial telnet::3000,server -hda 
>./netbsd-615-sparc64.raw -cdrom ./NetBSD-6.1.5-sparc64.iso -boot d -net 
>nic -net user
>
>Run installed system (use wd0a if asked)
>~/qemu/sparc64-softmmu/qemu-system-sparc64 -m 1024 -nographic -monitor 
>telnet::4440,server,nowait -serial telnet::3000,server -hda 
>./netbsd-615-sparc64.raw -cdrom ./NetBSD-6.1.5-sparc64.iso -boot c -net 
>nic -net user
>
>telnet localhost 3000 - guest
>telnet localhost 4440 - qemu monitor