Re: Sun QLogic SCSI HBA issues

Not sure I quite understand; but, I'll give it a go. Can you send me a 
link to the new build when your done?


On 2019-01-10 18:14, Martin Husemann wrote:
> On Wed, Jan 09, 2019 at 07:03:11PM +0900, Christian Rodriguez wrote:
>> The following values show up during detection of the SCSI HBA and drive:
>> "*0x12000", "0x22000", "0x52000", "0x62000", "0x72000", and "0x82000"*.
>> Then, after detection it starts spamming a ton of messages with values like
>> *"0x952000", "0x992000", "0x9a2000", "0xa52000", *etc. It seems to just be
>> incrementing upward.
>>
>> Any idea what this could be about? I'm really curious.
> This decodes into:
>
> 		type	seq	cmd
> 0x012000	1	1	0
> 0x022000	1	2	0
> 0x052000	1	5	0
> 0x062000	1	6	0
> 0x072000	1	7	0
> 0x082000	1	8	0
>
> 0x952000	1	0x95	0
> 0x992000	1	0x99	0
> 0x9a2000	1	0x9a	0
> 0xa52000	1	0xa5	0
>
> where type = 1 means scsi initiator.
>
> This means that in the list of open commands, the first command (all or your
> values had cmd = 0) does not match the response from the device.
>
> I have changed the error message to give better diagnostics. Could you
> retry when the next autobuild is available?
>
> Thanks,
>
> Martin
>
-- 
Christian Rodriguez, SrA, USAF
RF Transmission Systems Technician
Kunsan, Republic of Korea
PACAF 8 CS/SCOT
DSN: 782-4919