Re: NetBSD installation on Sun Ultra 10

Connor McLaughlan <[email protected]>
Newsgroups gmane.os.netbsd.ports.sparc64
Message-ID <CABo1Du7i9ud-3P+49LeA=EdAf_4vahfBAEfECr+eQBhAG-08tQ@mail.gmail.com>
On Sun, Jul 26, 2020 at 7:15 PM Michael <[email protected]> wrote:
>
> Hello,
>
> On Sat, 25 Jul 2020 23:14:25 +0200
> Connor McLaughlan <[email protected]> wrote:
>
> > i can't boot the install cd on my Ultra 10. It seems to have problems
> > with the IDE controller or the CRD-8322B drive:
> >
> > [] wd0 ata atabus0 drive 0
> > [] wd0: <WDC WD800JB-00FSA0>
> > [] wd0: 76319 MB, 155061 cyl, 16 head, 63 sec, 512 bytes/sect x 156301488 sector
> > s
> > [] atapibus0 at atabus1: 2 targets
> > [] cd0 at atapibus0 drive 0: <CRD-8322B, 1998/09/24, 1.05> cdrom removable
> > [] WARNING: 2 errors while detecting hardware; check system log.
> > [] wdc_atapi_intr: bad data phase DATAOUT
> > [] cmdide0:1:0: reset failed
> > [] cmdide0:1:0: unbusy timed out
> > [] cmdide0:1:0: reset failed
> > [] cmdide0:1:0: unbusy timed out
> > ...
> > (conitinues and the install system never comes up)
> >
> > This error can be found on mailing lists dating back to NetBSD 5 / 2009.
> >
> > But there are people running NetBSD on the Ultra 10.
> > So what is the solution? Do i have to use a different kernel or a
> > different cdrom?
>
> That smells like a hardware problem, IDE cables get old and cause
> failures in weird places. An U10 is certainly old enough to do this.
> What I'd try, not necessarily in this order:
> - reseat all the IDE connections, check the connectors for damage,
>   rust, dirt etc.
> - replace the IDE cable
> - try to boot something else, like Solaris, to see if the problem is
>   NetBSD-specific.
>
> have fun
> Michael

Hi Michael,

i have already verified, that the problem is with the NetBSD kernel only.

Both Solaris and Linux sparc64 work just fine on the Ultra 10 and
CRD-8322B drive.
The CRD-8322B drive is from 1999 and seems to be the stock drive,
which made me wondering why there are not more problem reports.

I replaced the drive with a newer one for the installation of NetBSD
and my Ultra 10 is up and running now.
But of course i'd rather use the original drive again.

Here is where i found others to have the exact same problem since about NetBSD5:
https://mail-index.netbsd.org/tech-kern/2014/06/20/msg017259.html
https://mail-index.netbsd.org/port-sparc64/2009/08/12/msg001002.html

Regards,
Connor
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.