Re: sun blade 150 with xvr-100 issues with xorg

thanks! removing the busid seems to have gotten x starting now. Does
acceleration work good in it? I used the options in your xorg but
running glx gears only gives me about 8 frames/second. shouldn't it be
a bit higher than that?

On Fri, Aug 6, 2021 at 10:42 AM r34per <[email protected]> wrote:
>
> I got an xvr-100 to use instead of the onboard rage xl, but i've been
> having some trouble getting it to work with xorg. I've recompiled the
> kernel with insecure option enabled, as i had to to get the mach64
> driver working and as i understand needed for the xvr-100 as well. I
> have disabled the rage xl from obp, and netbsd seems to be finding the
> card and outputting to it in cli. Running X -configure seems to
> generate a valid config, but when i try running startx it says there's
> no screens found and errors out. I've not been able to find a solid
> fix for this, but from what i have found everything seems to be
> configured right. Looking through the xorg logs one portion of note is
> near the beginning of xorg.1.log-
> [ 873.038] (WW) xf86EnableIO -1
> [ 873.038] (II) xf86EnableIO: 0xffffffffffffffff
> [ 873.038] (WW) Can't map IO space! (9)
>
> and a similar warning is generated near the end of the log-
> [ 873.181] (WW) xf86EnableIO 8
> [ 873.181] (II) xf86EnableIO: 0x40b94000
>
> Also when looking through the dmesg output there's this that could be of note-
> [ 1.000000] drm at radeonfb0 not configured
>
> I'm at a loss at this point, and welcome any ideas for what i can do.
> I've attached the full output of xorg.1.log as well as dmesg, and also
> my xorg.conf file
>
> xorg log
> https://pastebin.com/v3NgiBj1
>
> xorg.conf
> https://pastebin.com/CMrGBC9r
>
> dmesg
> https://pastebin.com/xHL2J8T4