My sun3 has one db50-hd50 cable for the primary cpu-to-drives
run. Sadly, it is 5 feet long. The boxes used are now 4 x sun411
lunchbox drives (shortly to be upddated to a 911 box with 4 drives).
Originally, I could only get a maximum of 3 drives interconnected
with two 8 '' hd50 ribbon cables (special things I had made up).
The original terminator was a passive hd50 kind, which, as it turns
out, seems to be the culprit. I replaced it with a DEC active scsi
terminator from an Alpha 7000 machine that I scrapped a while back,
and that seems to have cured the problem. Now, the cable length
is 5 feet + (5x4" box cables) + (4x8" cables) = 112" (9'4"), which is
working. I have not tried to add an additional cdrom and its cable
(12" total), although I am expecting that should work. In my particular
case, it appears that the terminator block was the culprit. The 3/60
is now up on sunos 4.1.1U1, and hopefully will provide me a platform
to boot one of the drives in NetBSD and get up to current on that.
This kind of trouble caused me to wring my type 3 keyboards in the
air, one time, and chuck out a truckload of sun3 vme crates. But,
when I ran across this lonely, forgotten 3/60, I got bit by that sunbug,
again.....(:+}}..... (as it turns out this particular 3/60 had the good 3.0.1
prom in it so I can run the luncbox 150mb tape drives, which is nice).
Anyone know if there is a way to rebuild the cpu board to have either
a Centronics style output or an HD50 output plug instead of that
awful db50 thing? I was thinking it might be possible to header off
the internal unused 50 pin scsi dip thingy with say the cable out of
a 411 box. That would provide the hd50 output to make things a bit
more happy.
Thanks for the discussion and noggin'-scratchin'...(:+}}.....
Bob Keys
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.