Re: CMD controller not found on 4000/500A
Johnny Billquist <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.vax |
|---|---|
| Message-ID | <[email protected]> |
How much memory do the machine have?
Johnny
On 2024-02-17 21:48, George Harvey wrote:
> Hi,
>
> I have a 4000/500A with CMD CQD-223/TM SCSI controller. I did a network install of 10.0_RC3 onto a 4.3GB SCSI disk and it all proceeded normally until the reboot when the kernel failed to find the CMD controller. If I netboot the same kernel, it does find the CMD card and the system runs normally. I have since updated to the RC4 kernel and see the same behaviour. The relevant lines from kernel are:
>
> Netbooting 10.0_RC4 GENERIC
>
> [ 1.0000000] uba0 at mainbus0: Q22
> [ 1.0000000] mtc0 at uba0 csr 174500 vec 774 ipl 17
> [ 1.0000000] mscpbus0 at mtc0: version 4 model 14
> [ 1.0000000] mscpbus0: DMA burst size set to 4
> [ 1.0000000] uda0 at uba0 csr 172150 vec 770 ipl 17
> [ 1.0000000] mscpbus1 at uda0: version 6 model 13
> [ 1.0000000] mscpbus1: DMA burst size set to 4
> [ 1.0000000] qt0 at uba0 csr 174440 vec 764 ipl 17
>
> Booting the same kernel from the SCSI disk (DUA1):
>
> [ 1.0000000] uba0 at mainbus0: Q22
> [ 1.0000000] mtc0 at uba0 csr 174500 vec 774 ipl 17
> [ 1.0000000] mscpbus0 at mtc0: version 4 model 14
> [ 1.0000000] mscpbus0: DMA burst size set to 4
> [ 1.0000000] qt0 at uba0 csr 174440 vec 770 ipl 17
>
> The CMD card at mscpbus1 is missing when booted from disk.
>
> Looking back through the mailing list archives, I see something similar reported for 9.3 on a 705A in this thread:
>
> http://mail-index.netbsd.org/port-vax/2023/02/01/msg004175.html
>
> However, it doesn't look like a solution was found. Did anyone find a solution?
>
> George
>
>
--
Johnny Billquist || "I'm on a bus
|| on a psychedelic trip
email: [email protected] || Reading murder books
pdp is alive! || tryin' to stay hip" - B. Idol