Re: CMD controller not found on 4000/500A

Dave McGuire <[email protected]>
Newsgroups gmane.os.netbsd.ports.vax
Message-ID <[email protected]>
   I'm not sure I'd call it a smoking gun, but my 705A boots reliably 
now from a CMD CQD-223/TM.

   In sys/arch/vax/vax/ka680.c, in struct ka680_calls, there's a 
hard-coded timing value in member cpu_vups.  Change that to 45 or so. 
That made the difference here.

              -Dave

On 2/18/24 05:15, George Harvey wrote:
> On Sun, 18 Feb 2024 02:21:51 +0100
> Johnny Billquist <[email protected]> wrote:
> 
>> How much memory do the machine have?
>>
> 
> 128 MB, which is the same as the 705A that was showing similar symptoms in the linked thread.
> 
> George
> 
> 
>> On 2024-02-17 21:48, George Harvey wrote:
>>> Hi,
>>>
>>> I have a 4000/500A with CMD CQD-223/TM SCSI controller. I did a network install of 10.0_RC3 onto a 4.3GB SCSI disk and it all proceeded normally until the reboot when the kernel failed to find the CMD controller. If I netboot the same kernel, it does find the CMD card and the system runs normally. I have since updated to the RC4 kernel and see the same behaviour. The relevant lines from kernel are:
>>>
>>> Netbooting 10.0_RC4 GENERIC
>>>
>>> [   1.0000000] uba0 at mainbus0: Q22
>>> [   1.0000000] mtc0 at uba0 csr 174500 vec 774 ipl 17
>>> [   1.0000000] mscpbus0 at mtc0: version 4 model 14
>>> [   1.0000000] mscpbus0: DMA burst size set to 4
>>> [   1.0000000] uda0 at uba0 csr 172150 vec 770 ipl 17
>>> [   1.0000000] mscpbus1 at uda0: version 6 model 13
>>> [   1.0000000] mscpbus1: DMA burst size set to 4
>>> [   1.0000000] qt0 at uba0 csr 174440 vec 764 ipl 17
>>>
>>> Booting the same kernel from the SCSI disk (DUA1):
>>>
>>> [   1.0000000] uba0 at mainbus0: Q22
>>> [   1.0000000] mtc0 at uba0 csr 174500 vec 774 ipl 17
>>> [   1.0000000] mscpbus0 at mtc0: version 4 model 14
>>> [   1.0000000] mscpbus0: DMA burst size set to 4
>>> [   1.0000000] qt0 at uba0 csr 174440 vec 770 ipl 17
>>>
>>> The CMD card at mscpbus1 is missing when booted from disk.
>>>
>>> Looking back through the mailing list archives, I see something similar reported for 9.3 on a 705A in this thread:
>>>
>>>     http://mail-index.netbsd.org/port-vax/2023/02/01/msg004175.html
>>>
>>> However, it doesn't look like a solution was found. Did anyone find a solution?
>>>
>>> George
>>>

-- 
Dave McGuire, AK4HZ
New Kensington, PA
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.