Re: CMD controller not found on 4000/500A
Dave McGuire <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.vax |
|---|---|
| Message-ID | <[email protected]> |
On February 18, 2024 2:37:36 PM George Harvey <[email protected]> wrote: >> I'm not sure I'd call it a smoking gun, but my 705A boots reliably >> now from a CMD CQD-223/TM. >> >> In sys/arch/vax/vax/ka680.c, in struct ka680_calls, there's a >> hard-coded timing value in member cpu_vups. Change that to 45 or so. >> That made the difference here. > > I will give that a try and report back. Good luck. -Dave -- Dave McGuire, AK4HZ New Kensington, PA