On Tue, Jun 23, 2020 at 07:20:07AM -0700, Jason Thorpe wrote:
>
> > On Jun 23, 2020, at 12:23 AM, Ignatios Souvatzis <[email protected]> wrote:
> >
> > So, in short, you might need to switch your terminal program to 9600 after
> > the kernel boots.
>
> Ok, if I do: "consdev com0" and then reset my terminal program to 9600 it works. Thanks.
>
> This is the UEFI install image -- you'd think it would be able to get accurate info about the console settings from the UEFI environment?
No idea. My only NetbSD/UEFI setup is on an experimental new laptop.
I notice that on my other APU2 I have
% cat /boot.cfg
consdev=pc
menu=Boot normally:rndseed /etc/entropy-file;consdev com0;boot netbsd8
menu=Boot mp:rndseed /etc/entropy-file;consdev com0;boot netbsd-mp
menu=Boot mp2:rndseed /etc/entropy-file;consdev com0;boot netbsd-mp2
...
and
# /usr/sbin/installboot -ve /dev/rwd0a
File system: /dev/rwd0a
Boot options: timeout 15, flags 0, speed 115200, ioaddr 0, console pc
but this won't help you either, right?
So maybe compile the speed into the kernel.
-is
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.