Re: AX211 Wi-Fi not working on 7.9

Alex Mihajlov <[email protected]> Thu, 28 May 2026 17:00:47 +0300

Newsgroups	gmane.os.openbsd.bugs
Message-ID	<[email protected]>

On 28/05/2026, Alex Mihajlov wrote:

pcidump for this device is:
0:20:3: Intel Wi-Fi AX211
  0x0000: Vendor ID: 8086, Product ID: 7740
  0x0004: Command: 0006, Status: 0010
  0x0008:  Class: 02 Network, Subclass: 80 Miscellaneous,
    Interface: 00, Revision: 00
  0x000c: BIST: 00, Header Type: 80, Latency Timer: 00,
    Cache Line Size: 00
  0x0010: BAR mem 64bit addr: 0x000000405a704000/0x00004000
  0x0018: BAR empty (00000000)
  0x001c: BAR empty (00000000)
  0x0020: BAR empty (00000000)
  0x0024: BAR empty (00000000)
  0x0028: Cardbus CIS: 00000000
  0x002c: Subsystem Vendor ID: 8086 Product ID: 00e4
  0x0030: Expansion ROM Base Address: 00000000
  0x0038: 00000000
  0x003c: Interrupt Pin: 03 Line: ff Min Gnt: 00 Max Lat: 00
  0x00c8: Capability 0x01: Power Management
    State: D0
  0x00d0: Capability 0x05: Message Signalled Interrupts (MSI)
    Enabled: no; 1 vectors (1 enabled)
  0x0040: Capability 0x10: PCI Express
    Max Payload Size: 128 / 128 bytes
    Max Read Request Size: 128 bytes
  0x0100: Enhanced Capability 0x18: Latency Tolerance Reporting
  0x0080: Capability 0x11: Extended Message Signalled Interrupts (MSI-X)
    Enabled: no; table size 32 (BAR 0:8192)

> Hello.
> I installed OpenBSD 7.9 Release on a ThinkPAD T14G6 (Intel). When
> booting, I see the error message:
> "Intel Wi-Fi AX211" rev 0x00 at pci0 dev 20 function 3 not configured
> Full dmesg here:
> https://pastebin.com/raw/xNvkTfDb
> I also ran fw_update
> There is no Wi-Fi card in ifconfig.



-- 
С уважением, Михайлов Александр.

signature.asc (application/pgp-signature, 870 B)