3.4-beta on B132L and E55 / PCI support

Hi.

I am new to this list and OpenBSD. I instaled the 3.4-beta snapshot on
my 715/100XC and it seams to run fine. The installation was a bit
complicated. There was no lif34.fs as desribed in the installation
instructions. lif33.fs paniced at the end auf autoconf(9). So I used an
old 3.2 kernel with NFS root and did the disklabel / newfs / tar ... by
hand. The 3.2 kernel spit out some errors about osiop(4) and ie(4) but I
got the 3.4-beta snapshot onto the disk. 

BTW: Why did the kernel use the old Sun rarp/bootparamd method? Even the
boot ROM in the 715/100XC supported dhcp/bootp. 

Today I connected the disk from the 715/100XC to a B132L and it just
booted to multi user. (Serial console) I noticed that it says:
"WAX Bus Adapter" at phantomas0 (type b, sv 8e) offset fe00000 not
configured
"PCI Bridge" at phantomas0 (type d, sv a) offset ff80000 not configured
AFAIK WAX is the EISA bridge and the PCI bridge is the Dino chip. 
Is anyone working on an EISA and more interresting on a PCI attachment?
I have done some hacking on NetBSD/powerpc (PReP and CHRP) that included
PCI attachments. I am willing to work on the Dino / PCI support. But,
obviously, I don't want to duplicate work someone else is already doing.

I tried to boot the 3.4-beta snapshot on an E55 too. 
All I got was: [see dmesg below]
So it seams that this machine is not supported in any way?
Again: I am willing to do some work on the support for this machine. It
looks like it paniced somewhere in the pmap(9) module and I am not aware
of uvm(9) / pmap(9) internas. So this may exceed my current skills. But
if someone else supplies a kernel I will throw it at may hardware. 

>> OpenBSD/hppa BOOT 0.8
booting dk0a:/bsd: 2565460+40960+405504 [52+119840+100644]=0x422eec
SPID bits: 0x0, error = -2
WARNING: PDC_COPROC error -3
[ using 220908 bytes of bsd ELF symbol table ]
WARNING: BTLB address misaligned pa=0xfff40, len=0x80
pmap_pagealloc fail
panic: pmap_kenter_pa: cannot allocate pde for va=0xfff78000
Stopped at      Debugger+0x18:  break   0,5
RUN AT LEAST 'trace' AND 'ps' AND INCLUDE OUTPUT WHEN REPORTING THIS
PANIC!
DO NOT EVEN BOTHER REPORTING THIS WITHOUT INCLUDING THAT INFORMATION!
ddb> trace
Debugger(2a424c,f088f592,0,3a8) at Debugger+0x18
panic(2dd308,fff78000,0,3a8) at panic+0xf8
panic(29e1d4,35eec,29e63c,46d000) at panic+0xdc
pmap_kenter_pa(4aa280,ffffffff,602000,4680e0) at pmap_kenter_pa+0xd0
mbus_add_mapping(5a5000,451000,5a3803,2000) at mbus_add_mapping+0x264
mbus_map(0,0,7f8008,0) at mbus_map+0x78
comcnprobe(0,0,0,0) at comcnprobe+0x5c
cninit(0,0,0,0) at cninit+0x34
consinit(0,0,0,0) at consinit+0x38
main(0,0,0,0) at main+0x6c
-- trap #0
$callmain+0x8:
ddb> ps
   PID   PPID   PGRP    UID  S       FLAGS  WAIT       COMMAND
ddb>




------------------------------------------------------------------------------
   PDC - Processor Dependent Code - Version   2.0
   (c) Copyright 1990-1993, Hewlett-Packard Company, All rights reserved
------------------------------------------------------------------------------
   192 MB of memory configured and tested.
   Primary boot path:    56/52.6   (dec)
   Alternate boot path:  56/52.0   (dec)


Information Menu: Enter command > all

PROCESSOR

   Processor Speed (MHz):            96     (0x00000060)
   Hardware Version:              18481     (0x00004831)
   Software Version:               1153     (0x00000481)
   Software ID:               187944342     (0x0b33cd96)
   Software Capability:       268435696     (0x100000f0)
   CPU Revision:                     11     (0x0000000b)

FLOATING POINT COPROCESSOR

   Model:                            13     (0x0000000d)
   Revision:                          1     (0x00000001)

CACHE INFORMATION

   Instruction Cache Size:       524288     (0x00080000)
   Data Cache Size:              524288     (0x00080000)

PDC INFORMATION

   PDC Version:                      32     (0x00000020)

BOOT INFORMATION

   Autoboot:             ON
   Autosearch:           ON
   Primary boot path:    56/52.6   (dec)
                         38/34.6   (hex)
   Alternate boot path:  56/52.0   (dec)
                         38/34.0   (hex)
   Console path:         56/56.0   (dec)
                         38/38.0   (hex)
   LAN Station Address:  080009-7b7b1e
   BootTimer:            0      1 second

   Tue Sep  16 17:06:35 GMT 2003    (20:03:09:16:17:06:35)


CARD INFORMATION

   Path          Type             Slot Mod HVERSION SVERSION IODC Ver
IODC HV
   ----          ----             ---- --- -------- -------- --------
-------
   56            Bus Converter    14    0   0x5030 0x00000c00  0x00    
0x00   
   56/52         A DMA I/O        13    0   0x0440 0x00003980  0x04    
0x00   
   56/53         A Direct I/O     13    1   0x0040 0x00003a80  0x00    
0x00   
   56/56         A Direct I/O     14    0   0x0440 0x10000d00  0x03    
0x00   
   60            Bus Adapter      15    0   0x0111 0x00008100  0x00    
0x00   
   60/6          Foreign Module    1    2   0x0111 0x00008a00  0x02    
0x00   

MEMORY MODULE INFORMATION

   Slot               Card Size        Amount Enabled
   ----               ---------        --------------
    0A,  0B            16 MB            16 MB
    1A,  1B            16 MB            16 MB
    2A,  2B            32 MB            32 MB
    3A,  3B            32 MB            32 MB

   Physical   Memory:   192 MB     (0x0c000000)
   Configured Memory:   192 MB     (0x0c000000)

Information Menu: Enter command > 
-- 


tschüß,
       Jochen

Homepage: http://www.unixag-kl.fh-kl.de/~jkunz/