Re: 12/20 snapshot osiop(4) changes ?

re
sorry folks.
i've accidently screwed sti last week and now
it's all fixed (wait till your mirrors update).
cu

Making, drinking tea and reading an opus magnum from Brian A. Seklecki:
[Charset ISO-8859-1 unsupported, filtering to ASCII...]
> On 12/22/03 00:50:21, Brian A. Seklecki wrote:
> > ...my "HP 9000/712/60 (Gecko) PA-RISC 1.1f" won't boot past the SCSI  
> > disk probe.  it works with the 3.4 release kernel/lif.  there's some  
> > HP debugging codes listed but i doubt they're very insightful.  how  
> > do i go about jumping into the kernel debugger and running a  
> > backtrace from here?
> >
> 
> The 3.4 release kernel worked with the -current userland.  i guess  
> kernel<>userland data structures havn't changed much.  I was able to  
> recompile the -current kernel w/o a "st1 at * " stanza and able to boot  
> a -current kernel.
> 
> -lava
> 
> > osiop0 at gsc0 offset 6000 irq 9: NCR53C710 rev 2, 40MHz, SCSI ID 7
> > scsibus0 at osiop0: 8 targets
> > osiop0: target 0 now using 8 bit 10 MHz 8 REQ/ACK offset xfers
> > sd0 at scsibus0 targ 0 lun 0: <SEAGATE, ST32430N SUN2.1G, 0444> SCSI2  
> > 0/direced
> > sd0: 2049MB, 3992 cyl, 9 head, 116 sec, 512 bytes/sec, 4197405 sec  
> > total
> > 0x02.CBF0
> > 0x02.503F
> > 
> > ...now, i notice on the 3.4 release kernel that the next step *would*  
> > be:
> > 
> > sti0 at mainbus0 offset 8000000 irq 11: HPA208LC640 rev 8.04;7, ID  
> > 0x2B4DED6D40A00499
> > sti0: 2048x1024 frame buffer, 640x480x8 display, offset 0x0
> > sti0: 8x16 font type 1, 16 bpc, charset 0-255
> > 
> > ...why perhaps could explain why i'm seeing a "hang", as I'm booted  
> > using a serial console per the FAQ instructions.  perhaps i'm not  
> > seeing a SCSI problem, but perhaps a sti(4) / video / serial console  
> > problem?
> > 
> > the last snapshot i installed couldn't have been more than 6 weeks  
> > old.
> > 
> > ...thoughts?
> > -lava
> 


-- 
    paranoic mickey       (my employers have changed but, the name has remained)