Re: wsdisplay_console_initted assert on 712/100 and Oct 24 snapshot

On Mon, Dec 09, 2002 at 08:23:42AM +0000, Miod Vallat wrote:
> > I know the October 24 snapshot is old but I just came arround to
> > test it on my HP 712/100.
> > 
> > It assert in wsdisplay_console_initted.
> 
> This is a known problem that is currently not solved. To prevent it,
> boot -c and disable wsdisplay.
> 
> Miod

Oh, I didn't think it was an optional driver.

The system works now. Thanks all.

dmesg:

pdc_coproc: c0, c0
[ bsd ELF symbol table not valid: bad magic ]
[ using 126128 bytes of bsd a.out symbol table ]
pdc0: console init
Copyright (c) 1982, 1986, 1989, 1991, 1993
	The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2002 OpenBSD. All rights reserved.  http://www.OpenBSD.org

pmap_init()
OpenBSD 3.2-current (SHEPHERD_PIE) #741: Thu Oct 24 08:13:11 EDT 2002
    [email protected]:/export/hppa/root/sys/arch/hppa/compile/SHEPHERD_PIE
HP9000/712/100 (King Gecko) PA-RISC 1.1e
real mem = 67108864 (524288 reserved for PROM, 4194304 used by OpenBSD)
avail mem = 53637120
using 1630 buffers containing 6676480 bytes of memory
User Kernel Config
UKC> disable wsdisplay
  0 wsdisplay* disabled
UKC> quit
Continuing...
mainbus0 (root) [flex fff80000]
pdc0 at mainbus0
mem0 at mainbus0 offset ffbf000: viper rev 0, size 64MB
cpu0 at mainbus0 offset ffbe000 irq 31: PCXL L1-A 100MHz, FPU PCXL (CMOS-26B) rev 1
cpu0: 128K(32b/l) Icache, 128K(32b/l) wr-back coherent Dcache, 64 coherent TLB, 8 BTLB
lasi0 at mainbus0 offset 100000 irq 28: rev 3.0
gsc0 at lasi0
"PS/2 port" at gsc0 (type a, sv 84) offset 8100 not configured
"PS/2 port" at gsc0 (type a, sv 84) offset 8000 not configured
"floppy controller" at gsc0 (type a, sv 83) offset a000 not configured
"Advanced audio (ext.)" at gsc0 (type a, sv 7b) offset 4000 not configured
lpt0 at gsc0 offset 2000 irq 7
com0 at gsc0 offset 5000 irq 5: ns16550a, 16 byte fifo
ie0 at gsc0 offset 7000 irq 8:  LASI/i82596CA v1.0, address 00:60:b0:20:82:1e
osiop0 at gsc0 offset 6000 irq 9: target 7, NCR53C710 processor @ 40MHz
osiop0: id 7 reset V2
scsibus0 at osiop0: 8 targets
osiop0: target 4 now synchronous, period=100ns, offset=8
sd0 at scsibus0 targ 4 lun 0: <SEAGATE, ST32151N, HP02> SCSI2 0/direct fixed
sd0: 2048MB, 4177 cyl, 8 head, 125 sec, 512 bytes/sec, 4194685 sec total
sti0 at mainbus0 offset 8000000 irq 12: HPA208LC640 rev 8.04;7
sti0: 2048x1024 frame buffer, 640x480x8 display, offset 0x0
sti0: 8x16 font type 1, 16 bpc, charset 0-255
wsdisplay at sti0 not configured
nfs_boot: using network interface 'ie0'
nfs_boot: client_addr=192.168.12.5
nfs_boot: server_addr=192.168.12.1 hostname=hp712
root on jwales:/home/nfs/hp712/root
root time: 0x3df4c893
swap on jwales:/home/nfs/hp712/swap
swap size: 0x20000 (blocks)
init: copying out path `/sbin/init' 11
ie0: receive descriptors out of sync at 47
ie0: reset




-- 
Hugo Villeneuve <[email protected]>
http://EINTR.net/