Re: HP 9000 K200 (819) ... Headway made!!!

On Thu, 20 Dec 2007, Eric Schnoebelen wrote:

> Date: Thu, 20 Dec 2007 15:42:08 -0600
> From: Eric Schnoebelen <[email protected]>
> To: [email protected]
> Subject: Re: HP 9000 K200 (819) ... Headway made!!! 
> 
> Any chance you can get it booted into HP-UX, and run ioscan(1m)?
>
> ``ioscan -f'' would provide useful information about the disks
> that are attached.

I will do.  The HPUX boot currently takes about 30-50 min owing to
a misconfigured network ... so it'll be about an hour to get you the
ioscan -f  stand by.

Rob.

>
>> From the looks of things, OpenBSD is finding the devices
> attached to the single ended, narrow controller, but not the
> devices attached to the other (probably a wide, high voltage
> differential controller.)
>
> I'd *guess* that the HVD controller is attached to the uturn1,
> which doesn't seem to be probing well. (if I'm remembering the
> dmesg's correctly.)
>
> I hope this helps,
> 	Eric
>


-- 
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=--=-=-=-=
Robert S. Sciuk		http://www.controlq.com		259 Simcoe St. S.
Control-Q Research	tel: 905.576.8028		Oshawa, Ont.
[email protected]	fax: 905.576.8386  		Canada, L1H 4H3