Re: hme(4) on hppa?

On Tue, 27 May 2008 08:37:25 +0200
Miod Vallat <[email protected]> wrote:

> > Which compiled fine, although dmesg looks a little confused:
> >
> > "Sun PCIO EBus2" rev 0x01 at pci3 dev 0 function 0 not configured
> > hme0 at pci3 dev 0 function 1 "Sun HME" rev 0x01: line 4 irq 2,   
> > address 08:00:20
> > :aa:dd:d8
> > ukphy0 at hme0 phy 1: Generic IEEE 802.3u media interface, rev. 1:   
> > OUI 0x006051,
> >  model 0x0000
> [...]
> 
> > They show up in ifconfig -a, I'll test later if they actually work. :-)
> 
> You may want to uncomment the qsphy entries in GENERIC as well.
> 
> Miod
> 
> 

Should work with qsphy. I was running one for a short time on an 
Staccato/a-class a180c around v4.1. Was getting a few lost interrupt
type messages under heavy loads, but that could've just been the 
180mhz PA7300 not being able to peddle fast enough. Good idea to 
enable it in GENERIC as Miod suggested.

Al.


-- 
Alastair Boyanich <[email protected]>
This is an email from Fujitsu Australia Software Technology Pty Ltd, ABN 27 003 693 481. It is confidential to the ordinary user of the email address to which it was addressed and may contain copyright and/or legally privileged information. No one else may read, print, store, copy or forward all or any of it or its attachments. If you receive this email in error, please return to sender. Thank you.

If you do not wish to receive commercial email messages from Fujitsu Australia Software Technology Pty Ltd, please email [email protected]