Re: 6.4/hppa regression: no LAN or UWSCSI on C360

Miod Vallat <[email protected]> writes:
>> I've just been trying to install OpenBSD on an HP C360, and running into
>> some problems.  OpenBSD 6.4 boots okay, but it does not recognize either
>> the machine's LAN interface or its internal ultra-wide SCSI bus, making
>> it pretty much useless except as a doorstop.

> Argh. This is a regression in the installation kernel only, which was
> introduced by changes I wrote in the 6.4 development cycle. I
> incorrectly removed the attachment rule for dino at uturn1. Sorry about
> that.

Thanks for the quick response!

> Unfortunately, there is no easy way to repair this from UKC; but if you
> are able to use a serial console during the installation or upgrade, you
> may use UKC to swap uturn0 and uturn1; instead of losing the on-board
> devices (Ethernet, SCSI), this will lose the PCI cards (and thus, the
> display).

Meh --- think I'll just wait for the fix to reach the snapshot build,
and then install from that.  I'm waiting on a replacement disk to
show up before I can really go past the "does it boot" stage, anyway.

Again, thanks for the quick assistance.

			regards, tom lane