Mac LCII + FPU works with 3.5 [was Re: 68k support status page]

On Sat, May 15, 2004 at 04:41:18AM -0700, Thomas Carlson wrote:
> On May 14, 2004, at 11:00 PM, Hugo Villeneuve wrote:
> 
> >On Fri, May 14, 2004 at 07:49:04AM -0700, Thomas Carlson wrote:
> >>Hugo, one place that doesn't laugh at you is Micromac.  They have FPUs
> >>for most of the old Macs.  Check out their selection at:
> >>
> >>http://www.micromac.com/products/fpus.html
> >

Micromac (billing under MacUpgrade Specialists) were able to provide
me with a 68882 20MHz PLCC FPU which I have received yesterday.

So my LCII is now working perfectly but very slowly. (Tried that
ubench thingee: got 122 on it!)

The Asente MCLC 10baseT LC PDS ethernet card gets detected as "ae0
at nubus0" and works OK. Had to plug it into a fixed 10mbit/half-duplex
hub. My auto-sensing hub didn't like it. It also seems to have
problem with multi-cast as I had to disable ipv6 because of problems
with neighbour advertisement and discovery. (My quadra 650 with a
sn0 doesn't have that problem.)

I said it before but without the FPU, this machines can boot into
single user mode but fails to run about every command.


dmesg for:
Macintosh LCII (16MHz 68030)
+ Asente LC PDS ethernet card (MCLC/MCiLC)
+ 68882 FPU (in socket of ethernet card)


OpenBSD 3.5-stable (GENERIC) #0: Sun May 30 18:16:01 EDT 2004
    [email protected]:/usr/src/sys/arch/mac68k/compile/GENERIC
Apple Macintosh LC II, 68030 CPU+MMU, MC6882 FPU
real mem = 10485760 (10240K)
avail mem = 5984256 (5844K)
using 153 buffers containing 626688 bytes (612K) of memory
mrg: 'Mac Classic II ROMs' ROM glue, tracing off, debug off, silent traps
mrg: I/O map kludge for ROMs that use hardware addresses directly.
adb: bus subsystem
mrg: skipping egret setup
adb: calling ADBReInit
adb: using IIsi series hardware support
adb: cleanup: (length=0x2):  0xff  0x03
adb: ADBReInit complete
adb: mapped device (5) at 2
adb: 100 dpi mouse at 3
mainbus0 (root)
obio0 at mainbus0
adb0 at obio0 (ADB event device)
asc0 at obio0: Apple Sound Chip
intvid0 at obio0: Internal Video
intvid0: 512 x 384, monochrome
grf0 at intvid0
ite0 at grf0 (minimal console)
ncrscsi0 at obio0
scsibus0 at ncrscsi0: 8 targets
sd0 at scsibus0 targ 2 lun 0: <IBM, DPES-31080 !t, S31R> SCSI2 0/direct fixed
sd0: 1034MB, 4903 cyl, 4 head, 108 sec, 512 bytes/sec, 2118144 sec total
zsc0 at obio0 chip type 0 
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
nubus0 at mainbus0
ae0 at nubus0: address 00:00:94:6a:8c:1b, type MacCon LC - A , 32KB memory
root on sd0a swap on sd0b
PRAM: 0x40be7979, macos_boottime: 0x40be7968.