Re: Fujitsu Futro S9010n blank screen after initializing inteldrm

Hi,

thanks Dan,
without xorg.conf it's just disabled, like DP-2 output.
because it goes blank even before starting xorg, I think it's more a
inteldrm issue, than xorg.
With disabled inteldrm, it doesn't try to switch graphics mode, and monitor
doesn't go blank, and I can actually log in at the console.
but without inteldrm, startx doesn't even start up at all.

Sebastian


On Tue, Jun 9, 2026 at 11:53 AM dan <[email protected]> wrote:

>
> I own an old Fujistu (a mini pc) coming from Germany, although not exactly
> the same model of you.. Years ago, at my first boot to make it run
> smoothly, I disabled the TPM by the bios (manage it with care if you go
> there, at your own risk).
>
> However I also noticed this:
>
> [    14.067] (II) modeset(0): Output DP-1 enabled by config file
> [    13.270] (**) modeset(0): claimed PCI slot 0@0:2:0
>
> Your configuration is almost incomplete missing almost the port
> declaration..
>
>
> --
> dan
> pls connect by [email protected]
> or surf my bsd blog at bsd.numode.eu
>
> From: Sebastian Reitenbach <[email protected]>
> To: [email protected]
> Date: Jun 8, 2026 23:12:35
> Subject: Fujitsu Futro S9010n blank screen after initializing inteldrm
>
> > I've got a bunch of those Futros on eBay, and they work great as fanless
> servers, just with serial console. I thought I could replace my incredibly
> aging desktop with one of those ones as well.
>
>

-- 
https://buzzdeee.reitenba.ch