Re: Apparent problem with divert-to rule parsing

> > The following rule would not load:
> >
> > pass in quick on $IntIf inet proto tcp to port ftp divert-to lo0 port
> 8021
> >
> > The error message was:
> >
> > pf.conf:207: address family mismatch for divert
> >
> > If lo0 is replaced with 127.0.0.1 then it loads and works correctly.
> > However, 127.0.0.1 is properly substituted for lo0 when using rdr-to.
> >
> > George
>
> It would be nice if this worked, though it looks like it's non-trivial
> to do (rdr-to is parsed in a different way to divert-to) - however, I'd
> like to make sure that at least the documentation for ftp-proxy is
> correct, did you find this rule in documentation somewhere?

The only place where I found divert-to being referenced was in the  
ftp-proxy documentation, and it was shown with "127.0.0.1". It was I  
that made the switch to lo0, to be consistent with other rules in the  
pf.conf.

Geo.