Re: PowerMac G5 (PowerMac7,3) radeondrm

On Fri, Dec 09, 2016 at 11:02:09AM -0800, Bryan Vyhmeister wrote:
> The only other issue is that one of the fans runs at full blast which
> is fairly loud. If I remember correctly, I have seen work on the G5
> fans on src-changes@ but not sure if this machine was one that would
> benefit from that work.

I made one silly mistake on the fans. The fan control is working
perfectly. I had just forgotten to put the clear plastic air shroud back
in after I switched my SSD to this system. Once I put the shroud back
in, the fans slowed down and are working perfectly as can be seen from
sysctl hw output below.

Bryan


hw.machine=macppc
hw.model=970 (Revision 0x202)
hw.ncpu=2
hw.byteorder=4321
hw.pagesize=4096
hw.disknames=cd0:,wd0:657a501240a85374
hw.diskcount=2
hw.sensors.lmtemp0.temp0=17.50 degC
hw.sensors.maxtmp0.temp0=33.38 degC (Internal)
hw.sensors.maxtmp0.temp1=45.50 degC (External)
hw.sensors.maxtmp1.temp0=22.88 degC (Internal)
hw.sensors.maxtmp1.temp1=16.50 degC (External)
hw.sensors.fcu0.fan0=0 RPM
hw.sensors.fcu0.fan1=999 RPM
hw.sensors.fcu0.fan2=1000 RPM
hw.sensors.fcu0.fan3=1000 RPM
hw.sensors.fcu0.fan4=999 RPM
hw.sensors.fcu0.fan5=1000 RPM
hw.sensors.fcu0.percent0=26.67% (PWM)
hw.sensors.fcu0.percent1=26.67% (PWM)
hw.sensors.adc0.temp0=33.00 degC (Internal)
hw.sensors.adc0.raw0=1023
hw.sensors.adc0.raw1=1023
hw.sensors.adc0.raw2=1023
hw.sensors.adc0.raw3=1023
hw.sensors.adc1.temp0=31.25 degC (Internal)
hw.sensors.adc1.raw0=1023
hw.sensors.adc1.raw1=1023
hw.sensors.adc1.raw2=1023
hw.sensors.adc1.raw3=1023
hw.cpuspeed=1800
hw.vendor=Apple Computer, Inc.
hw.product=PowerMac7,3
hw.physmem=805306368
hw.usermem=805294080
hw.ncpufound=2
hw.allowpowerdown=1