SMP on Compaq 1850R

just installed 3.6 release on a compaq 1850R dual P2-450mhz which 
appears to only see one cpu with the stock bsd.mp

ive googled but not come up with anything specific with this 
setup..anyone have any ideas?


OpenBSD 3.6 (GENERIC.MP) #173: Fri Sep 17 12:52:31 MDT 2004
    [email protected]:/usr/src/sys/arch/i386/compile/GENERIC.MP
cpu0: Intel Pentium II ("GenuineIntel" 686-class, 512KB L2 cache) 449 MHz
cpu0: 
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR
real mem  = 268001280 (261720K)
avail mem = 237600768 (232032K)
using 3297 buffers containing 13504512 bytes (13188K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(00) BIOS, date 12/31/99, BIOS32 rev. 0 @ 0xf0000
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x2000
pcibios0: PCI BIOS has 7 Interrupt Routing table entries
pcibios0: PCI Interrupt Router at 000:20:0 ("Intel 82371AB PIIX4 ISA" 
rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0x8000 0xc8000/0x4000 0xe8000/0x6000 
0xee000/0x2000!
cpu0 at mainbus0: (uniprocessor)
cpu0: Intel Pentium II ("GenuineIntel" 686-class, 512KB L2 cache) 449 MHz
cpu0: 
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82443BX" rev 0x02
siop0 at pci0 dev 6 function 0 "Symbios Logic 53c875" rev 0x14: irq 10, 
using 4K of on-board RAM

scsibus0 at siop0: 16 targets
siop1 at pci0 dev 6 function 1 "Symbios Logic 53c875" rev 0x14: irq 11, 
using 4K of on-board RAM
scsibus1 at siop1: 16 targets
tl0 at pci0 dev 7 function 0 "Compaq ProLiant Netelligent 10/100 TX" rev 
0x10: irq 15 address 00:08:c7:4f:f6:cb
lxtphy0 at tl0 phy 1: LXT970 10/100 media interface, rev. 3
ukphy0 at tl0 phy 31: Generic IEEE 802.3u media interface
ukphy0: OUI 0x100014, model 0x0001, rev. 5
vga1 at pci0 dev 8 function 0 "ATI Mach64 GV" rev 0x7a
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
"Compaq Netelligent ASMC" rev 0x00 at pci0 dev 9 function 0 not configured
ppb0 at pci0 dev 16 function 0 "IBM 82351 PCI-PCI" rev 0x07
pci1 at ppb0 bus 1
cac0 at pci1 dev 0 function 0 "Compaq SMART2P RAID" rev 0x03: irq 10 
Compaq SMART-2/P
scsibus2 at cac0: 1 targets
sd0 at scsibus2 targ 0 lun 0: <Compaq, RAID5 volume #, > SCSI2 0/direct 
fixed
sd0: 34727MB, 8716 cyl, 255 head, 32 sec, 512 bytes/sec, 71122560 sec total
fxp0 at pci0 dev 18 function 0 "Intel 82557" rev 0x02: irq 5, address 
00:a0:c9:70:07:1c
inphy0 at fxp0 phy 1: i82555 10/100 media interface, rev. 0
pcib0 at pci0 dev 20 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02
pciide0 at pci0 dev 20 function 1 "Intel 82371AB IDE" rev 0x01: DMA, 
channel 0 wired to compatibility, channel 1 wired to compatibility
atapiscsi0 at pciide0 channel 0 drive 0
scsibus3 at atapiscsi0: 2 targets
cd0 at scsibus3 targ 0 lun 0: <COMPAQ, CD-224E, 9.0B> SCSI0 5/cdrom 
removable
cd0(pciide0:0:0): using PIO mode 4, DMA mode 2
pciide0: channel 1 ignored (disabled)
uhci0 at pci0 dev 20 function 2 "Intel 82371AB USB" rev 
0x01pci_intr_map: no mapping for pin D
: couldn't map interrupt
"Intel 82371AB Power Mgmt" rev 0x02 at pci0 dev 20 function 3 not configured
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask 7fc5 netmask ffe5 ttymask ffe7
pctr: 686-class user-level performance counters enabled
mtrr: Pentium Pro MTRR support
dkcsum: sd0 matched BIOS disk 80
root on sd0a
rootdev=0x400 rrootdev=0xd00 rawdev=0xd02