X does not use Creator3D

Hi all,

I have an Ultra 10 Creator3D model with 4.6 installed.
As I only have a 13W3 monitor for it, I can't use the onboard Mach64,
but I need X.

/usr/X11R6/README suggests that I shouldn't need an xorg.conf, but
when I fire up X, it dies on the unconfigured Mach64, without any
sign of detecting the Creator. I dug up an old sparc xorg.conf from
CVS, but was still unable to configure X to use it with either sunffb
or wsfb. It seemed like the Creator was not even detected.

dmesg shows that the Mach64 is attached first, my only guess now is
to somehow reverse the order, but I don't know to do that.

Any other suggestions? What do I need to do to make this work?

Regards,
Peter