Re: X does not use Creator3D
Peter HEINER <[email protected]>
| Newsgroups | gmane.os.openbsd.sparc |
|---|---|
| Message-ID | <[email protected]> |
And indeed it does, thank you for your reply. peter On Wed, Dec 2, 2009 at 10:08 AM, Matthieu Herrb <[email protected]> wrote: > Peter HEINER wrote: >> Hi all, >> >> I have an Ultra 10 Creator3D model with 4.6 installed. >> As I only have a 13W3 monitor for it, I can't use the onboard Mach64, >> but I need X. >> >> /usr/X11R6/README suggests that I shouldn't need an xorg.conf, but >> when I fire up X, it dies on the unconfigured Mach64, without any >> sign of detecting the Creator. I dug up an old sparc xorg.conf from >> CVS, but was still unable to configure X to use it with either sunffb >> or wsfb. It seemed like the Creator was not even detected. > > You don't need an xorg.conf in most cases. But some specific > configurations still require one. > > In your case, iirc you can just disable machfb in the kernel > (/etc/boot.conf) and X should work on the ffb. > > >> >> dmesg shows that the Mach64 is attached first, my only guess now is >> to somehow reverse the order, but I don't know to do that. >> >> Any other suggestions? What do I need to do to make this work? >> >> Regards, >> Peter >> > > > -- > Matthieu Herrb